TOPCART LYNKS GT TROLLEYS
|
||
We are pleased to say that we have acquired the remaining stock from TopCart, and the
Lynksgt web-domain, and we will endeavor to supply service and repair parts for the TopCart trolleys well into the future.
Extremely popular strong trolley with unique folding technique, manufactured in Scotland until end of 09, used more than one control module & pot set ups, we do have a few of original PCB but recommend replace with our complete kit below, for potentiometer, use replacement as listed, only use our wired switched pot with our T4G kit.
Chinese imported lookalike not in the same league.
|
 |
|
 |
|
TopCart Golf Trolley.
|
NEW T4G KIT
 Module, potentiometer & molex replacement kit
|
The complete answer T4G module kit.
|
|
Use T4G kit to replace existing control module,
simple installation giving greater reliability and gentler power input, put a draw string on old harness before removing helps when feeding new one in,
  remove height adjusting bolt, makes easier to pull harness through, care when refitting so as not to snag new lead.
 use bullets supplied for motor wires,
NEW T4G KIT
|
|
 T4G module kit fitted
|
|
|
|
NEW T4G KIT
Replacement.
Potentiometer only as above.
 for kit with white molex 3 pin plug from module.
THIS IS A SWITCHED POTENTIOMETER.
Original hard wired module use non-switch below.
|
|
 NEW T4G KITReplacement module.
|
Old type PCB not available
 Use T4G kit above.
 |
|
 NON SWITCHED POT
Note no wires to rear od potentiometer, where the switch is!
|
To Switch or not to Switch!
All pots are generally the same, BUT can be wired switched or wired non-switched.
Top Cart generally apart from very early or very late models were fitted non-switched pot.
The fact that the pot clicks is not an indication of switched.
|
||
Late style switched pot.
  Opererates by pushing knob in.
If you have this housing purchase new soft housing
with switched pot.
|
|
Switched Potentiometer NON-SWITCHED POT
  |
Potentiometer original installation with
hard wired control module above with hard plastic housing, this potentiometer will fit housing.
 NON SWITCHED POT
|
|
  Hard plastic housing, won't take std 10k potentiometers.
|
Pot holder drilled.
 Plastic square cap potentiometer housing.
located to trolley with very short PK screw.
|
|
|
Pot Holder with potentiometer & knob.
 Assembled part
|
|
|
|
|
|
Pot knob small original spec.
 |
|
|
Small pot knob std
 One piece with grub screw.
|
|
|
 Molex leads.
|
|
|
 REPLACEMENT MODULE ONLY.
some of the later trolleys were
FITTED WITH T4G KIT ABOVE.
Uses switched pot.
|
|
|
Brush ring assembly
 Lemac brush ring 45111- 117
Easy repair kit
|
|
No soldering, no fiddly bits just swap it over.
|
Strain relief bush.
2713-018
 protects lead into motor can.
|
MOTOR BEARINGS
65178 type MOTORS
 |
|
 34711-004 Brushes.
As used in above assemblies.
|
|
|
|
|
|
Endshield brushgear assy.
45111-604
 Service part for
Topcart motors using 34711-015 brushes.
65157- 304 & others. not 309
£19.80 inc VAT
Please visually check the above there are two types, check wire layout.
|
|
|
 |
|
|
34711-015 brushes.
 As in above assembley
Brushes for later motors 65178-309
|
|
Two 34711-015 brushes.
Genuine parts!
|
 MOTOR only #65157- 001
 |
MOTOR REPLACEMENT
65157- 001
 |
|
|
 |
|
 |
||
Front Wheel suits TopCart, Greenhill, Fraser
and some older trolley types.
 Hub width 90mm, tyre width 84mm
diameter 120mm, spindle 8mm
Running on bearing race
below.
|
|
And other choices,
older trolley use G-TECH with bush.
|
Front hub bearings.
 |
|
|
Rear Wheel Spoke type
 includes "R" clip.
Complete with tyre.
|
|
EU SHIPPED IN PAIRS
|
|
|
|
Rear Wheel Solid type White
 FLEXI 17
|
|
Left side only
Discontinued item.
|
Wheels with inbuilt clutches will need maintenance
as with all mechanical device (cycle wheels etc)
Keep clean free of grit and lightly oiled.
DO NOT CLEAN CLUTCH AREA WITH JET WASH
THIS CAN BREAK SEALS.
or subjest to dragging through salt water sand etc without cleaning and oiling straight away.
|
|
|
Tyres for spoke wheels
 Diameter 255mm, width 89mm,
inside dia 185mm & 195mm (tapered)
inside rim 54mm.
|
|
|
TYRES FORE EARLIER FLEXI 17
 |
|
 |
Height adjuster plate.
 |
|
Height adjuster plate
|
Soft touch knob and bolt
 Centre frame adjustment.
|
|
Adjust knob & bolt.
|
 Soft touch adjust knob
|
|
Adjust knob
|
Centre Frame Bolt.
 8mm bolt for frame adjuster.
|
|
Bolt only
|
Top hat bushes for hinges
 tighten up that sloppy frame.
|
8mm x 12mm
A=12mm
C=8mm
 D=12mm
|
Pack of 8 peices
|
Axle bearings Early,
 28mm dia, 8mm W, 12mm int
|
|
One bearing shipped UK
|
Chassis service kit.
Top hat bushes, soft touch knob & bolt,
Potentiometer housing,
|
|
|
Axle carrier.
 |
|
One Nylon bearing.
|
Bag strap one peice,
 Max length 800mm
full velcro contact at 740mm
|
|
|
Trolley service.
  Chassis cleaned and painted.
|
   |
Trolleys can be collected serviced/repaired and shipped back.
Collection and return is £24.00.
Must be securley packed, don't need wheels or battery unless they may be suspect
 This older trolley had motor overhauled new brushes & bearings, new controller kit, new chassis bushes and bolts where necessary.
|
 |
|
 |
|
||
|
TOP QUALITY GOLF TROLLEY BATTERIES.
 |
|